Kenwood TR-7950 - APRS Forum at eHam.net

$\'\'$

$\'\'$

$\'\'$

eHam.net Forum : APRS : Kenwood TR-7950

Forum Help

1-2 of 2 messages

Page 1 of 1

Kenwood TR-7950	Reply
by CTHAM on April 24, 2009	Mail this to a friend!
So I brought this off ebay last night I do have a question since I want to use it just for APRS. I understand this is a 6 pin connection for the mic over the more common 8 pin connection. I was wondering what other ways I could connect my TT4 up?

RE: Kenwood TR-7950	Reply
by KB0NPW on May 27, 2009	Mail this to a friend!
I have the lower power model of that radio (7930) setup as a full-time digi. What I did was drill a tiny hole in the back of the case and run a short section of cable up to the back side of the mic jack. I soldered my necessary connections there. This way, if I want to take it off APRS and use it on voice, I can still plug my mic in on the front.

Page 1 of 1

Next Topic: D7A users in Houston area??
Previous Topic: packet radio on my Yaesu VX-170

Email Subscription
You are not subscribed to this topic.

Check our help page for help using Forum, or send questions, comments, or suggestions to the Forum Manager.

$\'\'$